Four Bottle Wine Rack - remix Home & Garden

11 Like

This is a version of the Four Bottle Wine Rack by Kevin Erickson, seen at The original model had stray lines, incomplete contours, and non-symmetrical shapes. Full credit should be given to Mr. Erickson, should you produce any versions of this. Cut from .071" or thicker steel, use an adjustable wrench to bend the hoops out at a 90° angle.

Remix Of
Creative Commons - Attribution

You may distribute, remix, tweak, and build upon this work, even commercially, as long as you credit Keith J Varin for the original creation.


4 years ago





  • Wine Rack.dxf
  • Kevin Erickson - 4 years ago
    Great update, Nice work!

  • Robert Phillips - 4 years ago
    FYI caution on the material you use. I had a lot of fun with this build. the first one I made out of .125 steel, and it worked fine. Then I made another out of .1875 steel and the tabs all crack / broke when bending them. I had to add a small weld at the crack. I then tested one tab without the small bending hole and it did not crack. so, if you plan to use metal thicker than .125, omit the bend line holes from your cutting geo. Have Fun! (this note added to ORG post also)

  • Chuck - 3 years ago
    Thanks man

  • scott - 2 years ago
    What's the measurements?

  • Steven Allen - 2 months ago
    this looks awesome. fixing to try cut one for my beach house bar

Authentication required

You must log in to post a comment.

Log in