Some of the areas within the map are pretty narrow at the 15" scale. I successfully cut it out of 18 gauge, 30 amp, 0.035" kerf width. If your kerf is wider, you may want to expand the scale, or modify some of the narrow points in the drawing.
mark dailey - 10 months ago
Any chance of making this cut ready? Just cant get the hang of programming.
Bret (OP) - 10 months ago
I haven't posted .nc files before because I assume people want to setup for the metal they'll use and there own preferred cut parameters.
I'll give it a try. What gauge metal will you be using?
mark dailey - 10 months ago
Bret: I will use 14 ga material.
I usually modify any of the cut ready files if i need to in Fireshare and have had real good luck. I just cant figure out how to use SheetCam.
Thanks, Mark
Bret (OP) - 10 months ago
I couldn't figure out how to add it to the original post so I listed it as a Remix.
mark dailey - 10 months ago
Thanks Bret.. will give it a try tomorrow and let you know
John LaNoue - 9 months ago
Sweet design, thanks! I think I will make it a bit larger, will look good on the office wall! Cheers
Bret (OP) - 10 months ago
mark dailey - 10 months ago
Bret (OP) - 10 months ago